Panel Track Blinds Throughout Geist

A wall of glass has nothing on it at all

The front panel rubs the door lever every time

The old track binds partway across the opening

Panels on the old track sag at the bottom edge

Light spills between panels in a dark bedroom

Afternoon glare crosses a whole living space

A great room wall reads as hardware, not fabric

Vertical vanes look dated on a modern opening

A nursery needs cover with no cord anywhere

The slider treatment stacks over the door handle

Stack depth calculated at the measure from the panel count, not estimated after the track arrives

Stack side agreed with you standing at the opening, one way to the left, one way to the right, or split to both ends

Channel count set against the opening width, since every channel adds a panel and every panel adds depth to the stack

Panel width and the overlap between panels worked out so the closed run covers the glass with nothing gapping

Track length extended past the trim on an outside mount so the stack lands on the wall rather than over the glass

Projection from the wall measured against handles, cranks and anything else living in or beside the opening

Finished width and height taken at three points each with a diagonal check, because a long track shows a slope immediately

Header substrate confirmed ahead of install day, since a loaded multi-channel track is heavier than it looks

Floor clearance set so the bottom weight bar sits clear of carpet, tile and any transition

Fabric chosen by what the opening needs, from an open solar weave with a stated openness factor to a room darkening face

Openness factor shown against your own glass rather than described, since the number means little until you see it

Woven wood panels sampled in your daylight where texture matters more than opacity

Draw side and control type settled per opening, wand or cord, with a tensioner fastened wherever a loop is used

Cord access on any corded draw specified to conform to ANSI/WCMA A100.1-2022

Motorized draw priced where a wide track would otherwise get drawn once and left alone

Panel attachment noted so you know which panels come off for cleaning and how they go back

A written contract covering scope, dates and the total price, per IC 24-5-11 on residential jobs over $150

Every panel drawn across the full track twice on install day so the carriers run without catching

Multi-channel headrail: The track itself, built with two, three, four or five channels depending on how many panels have to pass each other. The channel count is the single decision that sets both how the run behaves and how deep the stack ends up.

Panel width and overlap: Panels usually run somewhere between 18 and 24 inches wide, and each one overlaps its neighbor so the closed run reads as a continuous face. We do that arithmetic against your finished width instead of dividing by a round number.

One-way stack: Every panel gathers at a single end. It gives you the whole opening clear in one motion, and it puts the deepest stack you can build at that end, which is fine over a fixed panel and irritating in front of a door.

Split stack: Panels part in the middle and gather at both ends, which halves the depth at each side and looks balanced from the yard. It suits a wide opening with a walkway in the middle, and it needs an even panel count to look right.

Solar screen panels: An open weave with a published openness factor, so the panel cuts glare while the view survives. On a west wall this is the version people keep using, because the room gets comfortable without going dim in the middle of the afternoon.

Room darkening panels: A dense face that stops most light through the fabric itself. It gets a media room or a bedroom genuinely dim, and it doesn't seal, because panel edges and the track above them are still open by design.

Woven wood panels: Natural reed, bamboo or grass mounted as flat panels rather than as a rolling shade. The texture reads beautifully across a wide opening, and like every natural weave it passes light, so a liner comes into the conversation early.

Sheer panels: A translucent face that softens a view without closing it. It's what goes on a garden window wall or in front of drapery, and it does very little for privacy after dark once the lamps come on inside.

Hook-and-loop panel attachment: Most panels attach to their carriers with hook-and-loop tape, which means one panel comes off for cleaning or replacement without dismantling the track. It also means the panel goes back on straight only if you line it up carefully.

Motorized draw: A motor pulling the lead carrier across the track from a remote or a keypad. On a wide run it changes whether the treatment gets used daily. Plan on batteries as a recurring cost, since Hunter Douglas states PowerView life is about one year.